Replace EVO II Gimbal Camera

How To Replace The Gimbal Camera Of Autel EVO II Series?

Among commercial drones, only the Autel EVO II series of drone gimbal cameras can be replaced, you can get 6k gimbal cameras and 8k gimbal cameras and thermal imaging cameras. Advanced drones equipped with different gimbal cameras can be used in different scenarios to perform special task deployments.

Two EVO II series are currently available: EVO II Pro and EVO II Dual 640t,EVO II 6K gimbal cameras and EVO II 8K gimbal cameras are available.

Here we will introduce how to replace the gimbal camera of Autel EVO II series

Removing The EVO 2 Series Gimbal Camera

Before replacing the drone's gimbal camera, please make sure the drone is powered off;

Get your tools ready: t6 screwdriver, Philips screwdriver, plastic pick;

Before removing the drone's gimbal camera, remove the gimbal cover;

Extend the propeller arms of the drone and place the quadcopter up;

Use a t6 screwdriver to remove the two screws of the gimbal;

Remove the gimbal assembly cover and use a Philips screwdriver to remove the screws;

Use a plastic pick to lift the EVO 2 gimbal camera cable cover;

Hold the gimbal holder and remove the gimbal.

Mounting The EVO 2 Series Gimbal Camera

Align the gimbal vibration reduction bracket to ensure the correct position of the gimbal camera;

Install the pan/tilt cable cover and fasten it with a screwdriver;

Fasten the main cover of the gimbal and fasten it with screws;

Power on the drone and remote control after making sure the installation is complete;

Check the calibration status and image of the gimbal itself.

About gimbal calibration: How Do I Calibrate The EVO II Series Drone Gimbal?